cajomi
20.February2007, 09:57
Downloadlink:
www.cajomi.de/Up/GeoControlAlpha_Build9_Setup.exe (http://www.cajomi.de/Up/GeoControlAlpha_Build9_Setup.exe)
Bugfixes:
When the height was changed in the terrian panel, the iso height was not actualised, what could cause a crash
Terrains were not centered in the project panel
Crash, when drawing a isoline over the edge of the terrain
display of isolines was bad, with terrains greater than 1024
Stringfield "Isoheight" did not work
Changed
Reworked the isotool. The file format has changed, so old gts will not load proper. Also some internal caculations. Works now much better.
gts file now smaller
Display of isolines: All isolines are shown. The lines of the selected layer have a red border, selected isolines have a red/white border
The rubber only works on a selected line, but is now much easyser to use
The height of an isoline can be changed, after it was selected
Added:
Second height for isolines: The line starts with the first height and ends with the second. So, you can draw a sloped isoline
Isolayer typs: Absolute, for setting directly the height, add and subtract for relative changes. The two heights also work for add and subtract.
You can change the first and the second height, if the isoline is selected
The four sliders were replaced by a level control.
At all, the isoline tool works now, as it should. So try it out!!
Have fun
Johannes Rosenberg
-cajomi-
www.cajomi.de/Up/GeoControlAlpha_Build9_Setup.exe (http://www.cajomi.de/Up/GeoControlAlpha_Build9_Setup.exe)
Bugfixes:
When the height was changed in the terrian panel, the iso height was not actualised, what could cause a crash
Terrains were not centered in the project panel
Crash, when drawing a isoline over the edge of the terrain
display of isolines was bad, with terrains greater than 1024
Stringfield "Isoheight" did not work
Changed
Reworked the isotool. The file format has changed, so old gts will not load proper. Also some internal caculations. Works now much better.
gts file now smaller
Display of isolines: All isolines are shown. The lines of the selected layer have a red border, selected isolines have a red/white border
The rubber only works on a selected line, but is now much easyser to use
The height of an isoline can be changed, after it was selected
Added:
Second height for isolines: The line starts with the first height and ends with the second. So, you can draw a sloped isoline
Isolayer typs: Absolute, for setting directly the height, add and subtract for relative changes. The two heights also work for add and subtract.
You can change the first and the second height, if the isoline is selected
The four sliders were replaced by a level control.
At all, the isoline tool works now, as it should. So try it out!!
Have fun
Johannes Rosenberg
-cajomi-