Build 20 PW problems

[digitalis]

Johannes,

The PW-groups still give problems (as mentioned before).
Some detailed situations :
- PW-groups cannot be removed/changed , unless under the postwork tab a new filter is installed, then the previous one can be removed
- the generation tab did not show anymore in the above case, the 'do postwork' button remained in place
- also problems when changing terrain size, e.g. from 1024 to 2048 : then sometimes a 1024 pw group shows in the postwork tab whereas a 2048-group was selected under the generation tab

As for the height displacement filter : looks a bit confusing with two filter curves.
Two curves needed? Which curve is then implied?

Regards.

[cajomi]

The "selection" filter determine, how much the terrain is displaced. So this is the function which controls the displacement.
The general filter allows, to restrict where this displacement is proceeded.
So it is possible, to use a slope selection for the displace amount, and a height selection, where this discplacement should took place.

The pw-group is in work. Mostly deleting a pw-filter causes problems.
You can not select a pw-group in the filter panel. The pw-filter panel shows always the pw-group of the actual terrain size.

[digitalis]

As for the height displacement filter : what about the two "F" buttons, where you can manually create a height curve. Do these two curves also function?
Regards.

[cajomi]

They do function!!