height correction + brush is backwards

[kittle]

Ran into a wierd problem the other nite.

It seems if you have the height correction filter/shaper/whateverItsCalled as a part of your terrain and you use a brush to tweak things -- the brush just leaves a square blank spot with elevation 0.

Removing the height correction solves the problem. but then I have to remember what values I had for the height correction.

[imported_cajomi]

the update for GeoControl will be on the way today. Then it will work better with the height correction.
In general, push generate, and all those squares disappear.

[kittle]

the update for GeoControl will be on the way today. Then it will work better with the height correction.
In general, push generate, and all those squares disappear.
This wasnt a square line artifact that i was getting..
ALL the terrain inside the brush area was set to elevation 0.

I'll download the update and see if this is fixed.

[cajomi]

then I have misunderstand you. Hope it is also fixed with the update.

[monks]

Hello, I've just had a problem which sounds familiar. (version 1.01)
I imported a TG from Leveller. I set the protection and then the filter. Go back to Terrain tab and the Brush is leaving squares of 0 height. The protection slider is actually moving up an down on its own as I'm painting!! and the brush is getting smaller and smaller until it goes to 0 size. The brush size indicator is not changing however. I've restarted GC a few times and its still the same.

The behaviour isthe same even if you don't go into the Terrain SHape tab as well.

Cheers,
monks

[monks]

OK- I've worked out what's causing this. I imported a 4K terrain, rather that a 4096 terrain.

Cheers,
monks