Build 26 (pre-release) bugs

[mauronen]

Hi Johannes.
This time i haven't had more time to deep test GC2, but only to play with your fantastic tuts.
However i've discovered one little bug and one strange behaviour (i dont' want to call bug):


Postwork Section: when you type a value in Levelpower input text, for every filters, and press Retur, nothing happens
Postwork Section > Thin Flow Sediment filter: have you noticed GC2 behaviour when you set More sediments to 100? It seems to create random peaks on whole terrain. Behaviour is very different compared with values 99,98 and so on. Is a normal behaviour?

[cajomi]

First bug I have found. Have to be fixed!
Second: Depends on the slope dependence and the strength, only with a low slopedepence and high strength and level power the peaks appear. Well, to much power.
May I limit it down to 99.999999.

[WormSlayer]

Hi, just started using GeoControl, it really is amazing :)

But I've run into a bit of a problem with build 26 :(

I've been working on a heightmap for a few days but now when I load up the terrain settings, the "rivers and lakes" post work group is gone and I can no longer change the water settings? :(

Edit: GeoControl also locks up if I try and remove anything to do with water...

[cajomi]

That looks like a strong bug.

Did you proof, that you were in the right "level". I mean, the postwork group is only shown, if the actual size is the same as the level, where you had added a pw filter.

Please send me the terrain settings.

[WormSlayer]

You were right, I didnt realise there were separate postwork levels :)

[cajomi]

But the bug when you remove something with water is still there?

[WormSlayer]

I managed to lose my rivers and lakes postwork group again, I've emailed you the .gts file...

[cajomi]

After loading the gts I saw in the filter list, that the pw-group 2048 was disabled. That would explain, why other settings load just fine, but this not.

Did you disable it, before saving the preset?
But of course, it should be shown as disabled. Will fix that.

[cajomi]

The problem is here, that in the filter list (not the pw filter) the 2048pw group is disabled.
Enable it before generating, and all works fine.