GeoControl2 Build 43

[cajomi]

It has been a long term for the next update - but it is done now:

for full install:
GeoControl2 (http:///www.geocontrol2.com/Downloads/lktuiewwfefebztzrevvb/GeoControl2.exe)


for the update:
update_GeoControl2.exe (http:///www.geocontrol2.com/Downloads/lktuiewwfefebztzrevvb/update_GeoControl2.exe)


It was a long way, a real long way, but now is done.
So far the project tab has changed to the "Multi" tab. It is now all in the "Generation" tab, the "Project" tab is empty.
Over all there are five new panels (in the "Multi" section), similar to the old section.

Have fun
Johannes Rosenberg

[Abraham]

Thank you very much for this update Johannes.

[shadowphile]

can you clarify the full versus update links? I have a full version of build 42 installed at the moment.
thanks

[Abraham]

Hi Johannes, sorry to bring a bad news but there seems to be a little problem :(

- with the default project loaded, if I switch to 3D view all goes well.
- with the same project, if I create a road, do postwork and try to switch to the 3D view, geo-control stop working.
I tried several time with the same result

Jean-Luc

[cajomi]

This is solved for the next build. (geocontrol2 stops working)
Johannes

(max. 7 days)

[Abraham]

Thank you for the fast reply Johannes :)

[Seven-D.]

Sorry, it doesn't work.
After installing I'm not able to start Build43.
It simply doesnt do anything.
And when I try to deinstall it the installer freezes.

I'm working with Windows 7 64 bit.

[hhnguyen]

Same story here. After installation, the program does not do anything.
I also have Windows 7 64 bit.

hhnguyen

[cajomi]

That is really bad. I will see...................

[dballesg]

It was a long way, a real long way, but now is done.
So far the project tab has changed to the "Multi" tab. It is now all in the "Generation" tab, the "Project" tab is empty.
Over all there are five new panels (in the "Multi" section), similar to the old section.

Have fun
Johannes Rosenberg

But it's done :)

But due to the problems I'm reading, I will skip this build and wait for the next one. :rolleyes:


David

[dgrigo]

Hello ,
Running on 64 bit and i just want to clarify its working just needs to run in admin mode, and enter again the registration.

/wave

[Seven-D.]

Yep, you are right.
Works only in admin mode.

[Abraham]

I can confirm, also running windows 7 x64 and when run I start GeoControl in "run as admin" mode, the postwork problem disappear :)